Interface: Local Maintenance and Construction Vehicles - Local Maintenance Garages
Architecture Flow Definitions
maint and constr vehicle conditions (Planned ) Applicable ITS Standards
Vehicle diagnostics information that is collected, filtered, and selectively reported by a maintenance and construction vehicle. The information includes engine temperature, mileage, tire wear, brake wear, belt wear, and any warnings or alarms concerning the operational condition of the vehicle and ancillary equipment.
vehicle commands (Planned ) Applicable ITS Standards
System–level control commands issued to vehicle equipment such as reset and remote diagnostics.
vehicle configuration settings (Planned ) Applicable ITS Standards
Control settings and parameters that are used to configure vehicle equipment.
vehicle diagnostic data (Planned ) Applicable ITS Standards
Information about the vehicle and its current operational status that supports vehicle performance monitoring, service, and repair. The flow identifies the vehicle and vehicle type and provides information about the vehicle's current operational status, the current performance of engine–related and other components, and notification of any identified malfunctions.
vehicle service information (Planned ) Applicable ITS Standards
Vehicle problem diagnosis information and available vehicle service options, along with information about how to make a service reservation.
vehicle service request (Planned ) Applicable ITS Standards
Request for a service reservation from a connected vehicle.
vehicle service response (Planned ) Applicable ITS Standards
Response to a request for service reservation.
vehicle software install/upgrade (Planned ) Applicable ITS Standards
This flow supports installation and update of software residing in vehicle on–board equipment. It supports download of the software installation files, including executable code and associated support files.